Shure ULXD14/84 - Wailian Electronics Pte Ltd

Products

Shure ULXD14/84 Digital Wireless Lavalier Microphone System with WL184

($2,659.00 incl GST)

Large conference and convention installations come with unique wireless challenges. A campus-wide solution, ULX-D® Digital Wireless is secure, scalable, and durable. From managing diverse sound sources to protecting RF from smartphones and other stray signals, the intelligent system solves wireless problems of all sizes.

Note: This model will be delivered in individual packaging of ULXD4, ULXD1 and WL184.

Product Details
-

Shure ULX-D® Digital Wireless offers uncompromising 24-bit audio clarity and extremely efficient RF performance with single, dual, and quad channel receivers for any size professional sound reinforcement application. Generations ahead of any other available system in its class, ULX-D brings a new level of performance to professional sound reinforcement.

Uncompromising Professional Digital Wireless

24-bit/48 kHz digital audio that delivers incredibly clear and accurate sound reproduction
20 Hz – 20 kHz frequency range with flat response
Greater than 120 dB dynamic range
Wide selection of trusted Shure Microphones
Available in UHF, VHF and ISM (900MHz) Frequency Bands

Extremely Efficient and Reliable RF Performance

Up to 64 MHz overall tuning range (region dependent)
Up to 17 active transmitters in one 6 MHz TV channel (22 on an 8 MHz TV channel)
High Density mode enables up to 47 active transmitters in one 6 MHz TV channel
Rock-solid signal stability with no audio artifacts over the entire 100 meter range
Optimized scanning automatically finds, prioritizes, and selects the cleanest frequencies available

Scalable, Intelligent Hardware

Single (half-rack), Dual and Quad (full-rack) receiver form factors
AES 256-bit encryption equipped for secure wireless transmission
Dante™ digital networked audio over Ethernet
Wireless Workbench® 6 compatible for advanced coordination, monitoring and control; features Site Survey tool for scanning frequencies in the 902-928 MHz ISM band
Compatible with the Shure SB900A Rechargeable Battery and SBC chargers

Product Specifications
+

ULXD4 Specifications

Dimensions: 197 mm × 171 mm × 42 mm (7.75 in. × 6.75 in. × 1.65 in.), H × W × D
Weight: 913 g (2.0 lbs), without antennas
Housing: Galvanized Steel

RF Input

Spurious Rejection: >80 dB, typical
Connector Type: BNC
Impedance: 50 Ω
Bias Voltage: 12 - 13 V DC, 170 mA maximum, per antenna

Audio Output

Gain Adjustment Range: -18 to +42 dB in 1 dB steps (plus Mute setting)
Configuration:
- 1/4" (6.35 mm): Impedance balanced (Tip=audio, Ring=no audio, Sleeve=ground)
- XLR: Balanced (1=ground, 2=audio +, 3=audio -)
Impedance:
- 1/4" (6.35 mm): 100 Ω (50 Ω Unbalanced)
- XLR: 100 Ω
Full Scale Output:
- 1/4" (6.35 mm): +12 dBV
- XLR: LINE setting= +18 dBV, MIC setting= -12 dBV
Mic/Line Switch: 30 dB pad
Phantom Power Protection:
- 1/4" (6.35 mm): Yes
- XLR: Yes

Networking

Power Over Ethernet (PoE): No, protected
Network Interface: Single Port Ethernet 10/100 Mbps
Network Addressing Capability: DHCP or Manual IP address
Maximum Ethernet Cable Length: 100 m (328 ft)

ULXD1 Specifications

Gain Offset Range: 0 to 21 dB (in 3 dB steps)
Battery Type: Shure SB900A Rechargeable Li-Ion or AA batteries
Battery Runtime @ 10 mW:
- Shure SB900A: >11 hours
- Alkaline: 11 hours
- See Battery Runtime Chart
Dimensions: 86 mm × 66 mm × 23 mm (3.4 in. × 2.6 in. × 0.9 in.) H × W × D
Weight: 142 g (5.0 oz.), without batteries
Housing: Cast aluminum

Audio Input

Connector:
- 4-Pin male mini connector (TA4M)
- LEM03 connector
Configuration: Unbalanced
Impedance: 1 MΩ
Maximum Input Level (1 kHz at 1% THD):
- Pad Off: 8.5 dBV (7.5 Vpp)
- Pad On: 20.5 dBV (30 Vpp)
Preamplifier Equivalent Input Noise (EIN) - System Gain Setting ≥ +20: 120 dBV, A-weighted, typical

RF Output

Connector: SMA
Antenna Type: 1/4 wave
Impedance: 50 Ω
Occupied Bandwidth: <200 kHz
Modulation Type: Shure Proprietary Digital
Power :1 mW, 10 mW, 20 mW (See Frequency Range and Ouput Power table, varies by region)